2 Stroke KILLSWITCH LOCK INSTRUCTIONS

Installation Instructions – Killswitch Lock Assembly

Thank you for purchasing the Killswitch Lock Assembly from Qman’s Garage! Follow these steps to install your killswitch.

Note: You will need a 4mm hex key (not included).

Step 1: Mounting the Killswitch to the Handlebars

  1. Select a spot on your handlebar that is easy to reach.

  2. Use the provided clamp and M5 bolts to secure the killswitch in place.

    • DO NOT overtighten! Tighten until lock is secure on handlebar.

 

Step 2: Wiring the Killswitch

 

  • Your engine's CDI or ignition coil should have two wires used for the kill switch. These are the wires you'll be tapping into or connecting to.

Connecting the Wires:

Black Wire (Kill Wire) → CDI Kill Wire


  • If using Posi-Taps: Clamp the black wire from the lock onto the CDI’s kill wire.

  • If using Bullet Connectors: Plug the black wire from the lock directly into the CDI’s kill wire connector.

Red Wire (Ground Wire) → CDI Ground Wire

  • If using Posi-Taps: Tap the red wire into the CDI’s ground wire.

  • If using Bullet Connectors: Plug the red wire directly into the CDI’s ground wire connector.

 

Step 3: Securing the Wires

 

  • Route the wires neatly along the frame, keeping them away from moving parts or hot surfaces. Be sure to keep the wires away from the forks corners to avoid pinching. 

  • Use zip ties to secure the wires in place and prevent them from getting snagged.

 

Step 4: Testing the Killswitch

 

  1. Insert the key and turn it to the ignition position.

  2. Attempt to start the engine—it should start normally.

  3. Remove the key and try starting the engine again—the engine should NOT start.

 

 

Installation Complete!

If you have any questions or need help, contact us at info@qmansgarage.com.